DeWalt DWE46150 Original Instructions Manual page 21

2. Place the handle assembly over the grinder gear case
aligning the thumbscrews with the threaded holes
and the ears on the gear case with the slots in the bail
handle assembly.
3. Tighten the thumbscrews to secure the handle to
the grinder.
Adjustment of the bail handle angle
1. Loosen both thumbscrews 2 full turns.
2. Rotate the handle to the desired 45˚ or 90˚ position making
sure that the detent groves align.
3. Re-tighten the thumbscrews to secure the handle to
the grinder.
Edging Use Application (Fig. A)
This concrete grinding shroud has a door feature to allow flush
grinding against a wall.
1. Turn the tool off and disconnect it from the power source.
2. Using the edging door tab
snaps into the open postion.
3. Connect the tool to the power source.
4. Position hands and body away from wheel and
door opening.
5. Place the door edge flush to work surface, turn the tool on
and begin grinding. Remove the tool from work surface
before turning the tool off.
6. When flush grinding is complete, turn off the tool and
disconnect from power source. Allow the tool to stop
rotating before laying it down.
7. Using the edging door tab
the closed position.
MAINTENANCE
Your D WALT power tool has been designed to operate
e
over a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper tool
care and regular cleaning.

WARNING: To reduce the risk of serious personal
injury, turn tool off and disconnect tool from power
source before making any adjustments or removing/
installing attachments or accessories. Be sure the
trigger switch is in the OFF position. An accidental start-up
can cause injury.
Replace Brush Skirt (Fig. A)
1. Turn the tool off and disconnect it from power source.
2. Push worn brush skirt from brush skirt removal holes
3. Press new brush skirt into brush skirt removal holes
until secure.
Replacement brush skirts are available at additional cost from
your local dealer or authorized service center. If you need
assistance in locating any accessory, please contact one of the
authorized services centers listed on the back cover or refer to
the full details of our after-sales service available on the Internet
at: www.2helpU.com.
6 , rotate the edging door until it
6 , rotate door until it snaps into
.
4
Lubrication
Your power tool requires no additional lubrication.
Cleaning

WARNING: Blow dirt and dust out of the main housing
with dry air as often as dirt is seen collecting in and around
the air vents. Wear approved eye protection and approved
dust mask when performing this procedure.

WARNING: Never use solvents or other harsh chemicals
for cleaning the non-metallic parts of the tool. These
chemicals may weaken the materials used in these parts.
Use a cloth dampened only with water and mild soap.
Never let any liquid get inside the tool; never immerse any
part of the tool into a liquid.
Optional Accessories

WARNING: Since accessories, other than those offered
by D WALT, have not been tested with this product, use
e
of such accessories with this tool could be hazardous.
To reduce the risk of injury, only D
accessories should be used with this product.
Consult your dealer for further information on the
appropriate accessories.
Protecting the Environment
Separate collection. Products and batteries marked
with this symbol must not be disposed of with normal
household waste.
Products and batteries contain materials that can
be recovered or recycled reducing the demand for raw
materials. Please recycle electrical products and batteries
according to local provisions. Further information is available at
www.2helpU.com.
EngLIsh
WALT recommended
e
19