Yardworks YW50DHP Instruction Manual page 12

5. Add thread sealant (not included) and/or Teflon tape (not included) on to the suction inlet (3).
6. Align and screw the collar of the assembled inlet adaptor onto the thread on the
suction inlet (3) port of the pump (Fig. 5).
Note: Ensure the collar is tightly fastened onto the suction inlet; failure to do so may
result in an air leak.
Discharge Outlet
Connecting Hose or Pipe to the Discharge outlet
Note: Keep all hoses short and as straight as possible, failure to do so may decrease the pressure pumps
performance.
Caution: All connections require being air tight, failure to do so could result in an air leak which can prevent the
pump from priming. It is recommended that a thread sealant (not included) and/or Teflon tape (not included) is
applied to threads to ensure a water tight seal and prevent any leakage.
1. Assemble the 25.4mm (1") hose adaptor (18) by inserting into the 25.4mm (1")
collar (17) as shown in (Fig. 6).
Note: Ensure the 25.4mm (1") o-ring (20) is fitted into the 25.4mm (1") collar (17),
failure to do so may result in an air leak.
2. Determine which discharge outlet (2) port will be used. Screw the outlet caps (16)
onto 2 of the 3 discharge outlet (2) that are not going to be used.
Note: Multiple outlets can be used to pump water simultaneously but this will result in
lower pressure and flow rate.
Note: If the unused discharge outlets are not blocked off this will result in water expelling out of the discharge outlet
(2).
3. Add thread sealant (not included) and/or Teflon tape (not included) on to the
discharge outlet (2).
4. Align and screw the collar of the assembled inlet adaptor onto the thread on the
discharge outlet (2) port of the pump (Fig. 7).
Note: Ensure the collar is tightly fastened onto the discharge outlet (2); failure to do
so may result in an air leak.
SET-UP & INSTALLATION (cont.)
11
Fig. 5
Fig. 6
Fig. 7