Warning Signs - Bauer RAINSTAR A1 Operating Manual

The safety distances indicated in the above chart are valid for a nozzle diameter of 26 mm and/or 36 mm at an
operating pressure of 5 bar. For higher operating pressures the safety distances have to be increased by 2 m.
The safety distances are not valid when standardized jet pipes like those of fire brigades are being used.
When applying polluted water or slurry, note that a conductive layer can build up on the insulators. Therefore do
not spray on the insulators! Flashovers and insulator damage can otherwise cause power failure.
If metal sprinkler pipes are laid in parallel to a high voltage power line, this can lead even without irrigation to a
perceptible contact voltage because of the electric influence. Touching the pipes is not dangerous but can be
unpleasant and painful. This is why it should be avoided to lay metal pipes in parallel to high voltage lines or only
over the shortest distances possible. When using synthetic pipes, you will not encounter any of these problems.
Note! Do not put pipeline pieces into a vertical position in the range of high voltage lines! Only transport
them horizontally!

WARNING SIGNS

The hazard points of the RAINSTAR A1, A2 are marked by special safety labels on the machine. These
labels must be affixed well visibly to the points indicated and they serve to protect persons staying
around the machine.
1.
2.
3.
Manual for BAUER RAINSTAR A1, A2
WARNING !
Study and observe carefully the operating manual and the safety hints
before starting the machine.
WARNING!
Stop the machine and read the operating manual before carrying out
maintenance jobs and repairs.
WARNING!
1. The working range of the RAINSTAR A1, A2 always must be at a safe
distance from electric high-voltage lines.
2. The water jet of the nozzles and the sprinkler must not reach any
electric lines.
5