Operating Instructions - Flex DWL 2500 Instruction Manual

493.635_DWL 2500_12.0_18.0.book Seite 9 Donnerstag, 19. September 2019 1:19 13
DWL 2500 12.0/18.0V

Operating instructions

WARNING
Risk of electric shock! Before carrying out
any work on the power tool, always remove
the battery.
Before switching on the power
tool
Unpack power tool and accessories and
check that no parts are missing or damaged.
Inserting/replacing the battery
1. Press charged battery fully into
the power tool.
2. To remove the battery, press the
release buttons (1.) and pull out the
battery (2.).
CAUTION
When the device is not in use, protect the
battery contacts. Loose metal parts may
short-circuit the contacts; explosion and fire
hazard!
Battery state of charge
1. Press the button to check the state of
charge at the state of charge indicator
LEDs.
The indicator goes out after 5 seconds.
If one of the LEDs flashes, the battery must
be recharged. If none of the LEDs light up
after the button is pressed, the battery is
faulty and must be replaced.
Switching on and off
1. Switch the LED rechargeable work lamp
on and off by pressing the on/off switch.
Instruction manual
9