98
3-2. Opening, closing and locking the doors
Multi-information
Unlocking function
display/Beep
Holding the driver's
door handle unlocks
only the driver's
door.
Exterior: Beeps 3
Holding any of the
times
passenger door
handles unlocks all
Interior: Pings once
the doors.
Holding a door han-
dle unlocks all the
Exterior: Beeps
doors.
twice
Interior: Pings once
To prevent unintended triggering of the
alarm, unlock the doors using the wireless
remote control and open and close a door
once after the settings have been changed.
(If a door is not opened within 60 seconds
after
is pressed, the doors will be
locked again and the alarm will automati-
cally be set.)
In a case that the alarm is triggered, imme-
diately stop the alarm. (P.67)
Impact detection door lock release sys-
■
tem
In the event that the vehicle is subject to a
strong impact, all the doors are unlocked.
Depending on the force of the impact or the
type of accident, however, the system may
not operate.
Operation signals
■
Doors:
A buzzer sounds and the emergency flash-
ers flash to indicate that the doors have
been locked/unlocked. (Locked: Once;
Unlocked: Twice)
Windows and moon roof or panoramic
moon roof:
A buzzer sounds.
Security feature
■
If a door is not opened within approximately
60 seconds after the vehicle is unlocked,
the security feature automatically locks the
vehicle again.
When the door cannot be locked by the
■
lock sensor on the surface of the door
handle
When the door cannot be locked even if the
lock sensor on the surface of the door han-
dle is touched by a finger, touch the lock
sensor with the palm.
When gloves are being worn, remove the
gloves.
Door lock buzzer
■
If an attempt to lock the doors is made when
a door is not fully closed, a buzzer sounds
continuously for 5 seconds. Fully close the
door to stop the buzzer, and lock the vehi-
cle once more.
Setting the alarm
■
Locking the doors will set the alarm system.
(P.67)
Conditions affecting the operation of
■
the smart access system with push-but-
ton start or wireless remote control
P.114
If the smart access system with
■
push-button start or the wireless remote
control does not operate properly
Use the mechanical key to lock and unlock
the doors. (P.441)
Replace the key battery with a new one if it
is depleted. (P.389)
If the battery is discharged
■
The doors cannot be locked and unlocked
using the smart access system with
push-button start or wireless remote con-
trol. Lock or unlock the doors using the