Lexus RX350 Manual page 343

®
4 Test the HomeLink
pressing the newly programmed
button and observing the indicator
light:
 Indicator light illuminates: Program-
ming of a fixed code device has
completed. The garage door or
other device should operate when a
®
HomeLink button is pressed and
released.
 Indicator light flashes rapidly: The
garage door opener motor or other
device is equipped with a rolling
code. To complete programming,
firmly press and hold the Home-
®
Link button for 2 seconds then
release it.
 If the garage door or other device
does not operate, proceed to "Pro-
gramming a rolling code system".
5
Repeat the steps above to program
another device for any of the
remaining HomeLink
Programming a rolling code sys-
■
tem
2 or more people may be necessary to
complete rolling code programming.
1
Locate the "Learn" or "Smart" but-
ton on the garage door opener
motor in the garage.
This button can usually be found where the
hanging antenna wire is attached to the
unit. The name and color of the button may
vary by manufacturer. Refer to the owner's
manual supplied with the garage door
5-6. Using the other interior features
opener motor for details.
operation by
2 Press and release the "Learn" or
"Smart" button.
Perform
performing 2.
3 Press and hold the desired Home-
Link
®
buttons.
for 2 seconds and release it. Repeat
this sequence (press/hold/release)
up to 3 times to complete pro-
gramming.
If the garage door opener motor
operates when the HomeLink
button is pressed, the garage door
3
within 30 seconds after
®
button (inside the vehicle)
343
5
®