Kenwood Countdown TT500 Series Quick Manual page 5

2 Insert the bread, muffins, bagels etc.
3 Lower the lever
lever will not stay down unless the
toaster is plugged in).
A graduated LCD bar will appear at
the bottom of the display and as the
toasting cycle progresses, the bar
will gradually reduce in length.
To stop toasting at any stage, press
the 'cancel' button
Never lift the lever to cancel
toasting.
To toast frozen bread, press the
'defrost' setting
lowering the bread carriage.
DEFROST will appear in the display.
To warm toast that's popped up but
gone cold, press the 'reheat' button
before lowering the bread
carriage.
the display.
4 Your toast will pop up automatically
and an audible sound will be heard.
To raise the toast higher, lift the lever
.
If the toaster is connected to the
power supply but not used for
approximately 5 minutes the display
will remain on but the blue back light
will go out. This will come back on
when the lever
function button is pressed.
hints on using your
toaster
Select a lower setting for light
browning, for toasting one slice only
or for dry bread.
When toasting a single slice of
bread, you may notice a variation in
toast colour from one side to the
other - this is normal.
Dry/stale bread toasts more quickly
than fresh bread and thinly sliced
bread toasts more quickly than
thickly sliced bread. Therefore the
browning control should be set at a
lower setting than usual.
For best results ensure that the
until it locks. (The
.
before
REHEAT will appear in
is lowered or a
bread slices are of an even
thickness, freshness and size.
In order to achieve uniform browning
we recommend you wait a minimum
of 30 seconds between each
toasting so that the control can
automatically reset. Alternatively
select a lower setting when
additional toasting is carried out.
to use the warming rack
(TT505 series only)
1 Place the warming rack over the
centre of the toaster.
2 Put your food on the rack (slice thick
items in half to stop their outsides
burning). Watch to make sure it
doesn't burn, and turn it over half
way through.
3 Set the browning control no higher
than 4
4 Lower the lever.
5 The lever will automatically rise at the
end of the warming cycle.
6 To remove the warming rack, allow
the toaster to cool and unplug. Lift
off the warming rack.
care and cleaning
1 Before cleaning, unplug your toaster
and let it cool down.
2 Slide out the crumb tray
then replace. Do this regularly:
crumbs can smoke or even burn.
3 Wipe the outside of the toaster with
a damp cloth, then dry.
service
If the cord is damaged it must, for
safety reasons, be replaced by
KENWOOD or an authorised
KENWOOD repairer.
If you need help with:
using your toaster or
servicing or repairs
Contact the shop where you bought
your toaster.
3
. Clean,