Quick attachment
(CSERI)Hydraulic
Bucket
corner
Hydraulic hammer
10.3 Operation of the retro bucket
•
The retro bucket is adapted to dig the ground at a lev-
el below the machine.
•
The maximum digging force is obtained when the an-
gle between the bucket cylinder and the bucket arm and
the angle between the arm cylinder and the arm is 90°.
•
For maximum effectiveness, handle the arm within
the range illustrated opposite : 45° forward and 30° back.
•
Do not move the equipment to the end of the cylinder
run.
•
To dig at a level above the machine, install the buck-
et in the reverse position.
12.2.1 Loading bucket, page 109
10.1 Machine stability when using with a bucket
or an accessory, page 99
10.4 Digging trenches
•
To increase the effectiveness of the machine, place
an appropriate bucket to dig a trench and position the
tracks in parallel on each side of the trench to be dug.
•
To dig a wide trench, dig on the two sides then the
centre.
1 = Parallel
Retro bucket
Ditching bucket
Swivel ditching bucket
Loading bucket
10 Handling the bucket
HSW03
C TL2,5-700
C GL2,5-1200
C GLV2,5-1200
C TL2,5-600
C GL2,5-1200
DMS 165
103