Correct Use Of The Machine; User Requirements; Safety And Protective Systems; Informal Safety Measures - Hohner EXACT Operating Instructions/Spare Parts List

Basic safety precautions
The Wire Stitching Machine EXACT has been built according to state-of-the-art technology under
the observance of all the recognised safety regulations. It is, nevertheless, still possible when using
this machine to cause danger to life and limb of the user or a third party or to cause damage to the
machine or other property.
The machine should only be used,
• for the purpose for which it was designed
• when it is in a perfect technical condition
Faults that could reduce the levels of safety in using the machine must be removed immediately.
Warranties and liability on the part of the manufacturer are fundamentally covered by the regula-
tions laid down in our "General sales and delivery conditions".
1.5

Correct use of the machine

The Wire Stitching Machine EXACT is designed exclusively stitching of brochures and leaflets or
similar items. Any use of the machine contrary to that described above is forbidden since incorrect
use of the machine can present a danger.
1.6

User requirements

The user of the machine is required to provide the required personal safety equipment. All existing
safety systems should be checked regularly.
1.7

Safety and protective systems

All safety and protective systems must be attached to the machine and should be in full working
order before every start-up of the machine.
Safety and protective systems may only be removed:
• when the machine is stationary and
• after it has been secured against being started up again.
1.8

Informal safety measures

The Operating Manual should be stored in such a way as to be permanently to hand at the
machine. There are also generally valid local regulations concerning accident prevention and envi-
ronmental protection measures that should be made available and observed, in addition to those
described in the Operating Instructions.
All safety and danger signs on the machine should be maintained in a legible condition and should
be renewed where necessary.
1.9

Personnel training

Only skilled and trained personnel are allowed to work on the machine.
The responsibility of the various parties involved is laid out in the following table:
Transportation
Installation and commis-
sioning
Operation
Locating faults
Removing the fault
Setting up, equipping
Servicing
6
Trained persons
x
x
x
x
EXACT
06/2010
Specialists
A haulage company
The Hohner company,
Customer Service
The Hohner company,
Customer Service
Hohner Maschinenbau GmbH