To be able to take full advantage of all the possibilities of your new Retigo Hold-o-mat we recommend that you carefully study the manual before using the equipment.
OPERATING MANUAL FOR RETIGO HOLD-O-MAT 411 Content Introduction 1.1 Safety use of the equipment 1.2 Correct use 1.3 Electrical supply, power cable 1.4 Placement requirements 1.5 Gastrocontainers Content of packaging Rehinging the door Commissioning Operating of Retigo Hold-o-mat 411 5.1 Control panel 5.2 Basic operating instructions...
OPERATING MANUAL FOR RETIGO HOLD-O-MAT 411 Introduction mass production of food. People who are not familiar with the operating 1.1 Safety use of the equipment instructions such as children, must not use the unit, unless supervised by trained staff. Anyone who is involved in the setting up, use and...
OPERATING MANUAL FOR RETIGO HOLD-O-MAT 411 specialist electricians or by our repair service. Unsuitable GN - Plastic, synthetic and other non-heat resistant 1.4 Placement requirements containers. The Hold-o-mat can be used in many different parts Never use a damaged unit. Please note that the...
Page 6
OPERATING MANUAL FOR RETIGO HOLD-O-MAT 411 Customer service staff with active physical aids (such as heart pacema kers) must observe a safety distance of at least 0.5 m from the unit. The customer service operator must ensure that all other people with active physical aids (such as heart pacemakers) observe a safety distance of at least 0.5 m from the unit.
OPERATING MANUAL FOR RETIGO HOLD-O-MAT 411 without this sensor; these are described later on. Press and hold button 4 (Program/Enter) to start the pro- gramming mode in larger program in the middle. – The value to be changed “flashes” and can be changed with the Up or Down button.
OPERATING MANUAL FOR RETIGO HOLD-O-MAT 411 Practical tips Powerfail (default=5) Highest value (in degrees Celsius), which the unit may lose in the event of a power failure to restart 6.1 General use automatically – when power is restored – and continue with the program.
OPERATING MANUAL FOR RETIGO HOLD-O-MAT 411 If an over-warm product is put directly into the Hold- o-mat from a combisteamer, the actual temperature can rise dangerously depending on the product. (The indicator flashes, if the temperature is 5°C too high.)
OPERATING MANUAL FOR RETIGO HOLD-O-MAT 411 Troubleshooting Problem Cause Possible solution Set correct desired temperature or The product over-cooks and Desire temperature too high above allow meat that is too hot to cool becomes dry. core temperature outside the oven first.
Page 12
OPERATING MANUAL FOR RETIGO HOLD-O-MAT 411 Problem Cause Possible solution Temperature sensor (interior) Call for service: defective or not connected to the Sensor fail check change sensor control system. No further work reconnect contact (connector). possible. CTM sensor not connected to...
OPERATING MANUAL FOR RETIGO HOLD-O-MAT 411 8. Maintenance Warranty 8.1 Cleaning We guarantee the Hold-o-mat for one Switch off the unit with the button 1 and disconnect year. from the power supply. Take the trays, grilles and dishes out of the Hold-o- We do not accept responsibility for damage caused mat and clean separately.
Need help?
Do you have a question about the Hold-o-mat 411 and is the answer not in the manual?
Questions and answers