Settings; Adding Another Onis 200 Handset To The Base Station; Dect Peripheral Without Keypad - Philips TD6736/BH051P User Manual

Reglages 19/04/01 14:44

Settings

Adding another ONIS 200 handset to the base
station
You can use up to 8 handsets on the ONIS 200 base station.
A handset must be registered with the base station before it can be used with that base station.
To register a handset, use the following procedure:
Unplug and plug back the power adapter in
1
the base station. After a few seconds, the base
station will emit a double "tone".
Under the "Handset Settings" in the "Settings"
2
menu, scroll to "Register handset" and select
OK|.
Enter the 4-digit registration code on the base
3
station and select OK|.
L NOTE:
If the additional handset is not an ONIS 200 model but is GAP-compliant, refer to the relevant instructions.

DECT peripheral without keypad

Some DECT peripherals, such as repeaters, do not have a keypad. A special menu-operated procedure is
used to register such peripherals with the base station without the need to disconnect the base station.
Scroll to "Regist. Mode" under the
1
"Base settings" heading in the "Settings" menu
and select OK|.
Enter the registration code that comes with
2
the peripheral (e.g. 0000) and select OK|.
For the next 5 minutes, you can use the base
3
station to register your peripheral
(see peripheral instructions).
40
Page 40
Registration code:
_
CORRECT
Recording...
Registration code
_
CORRECT
Settings
The code is shown on the label
underneath the base station
(RC...).
OK
After a few moments, the screen
displays "Recording ...", followed
by "Set !". If this is not the case,
begin the procedure again.
OK