Advertisement
Install the DDR3-1600 REG Memory Kit
1．Preparation point to be checked
(1) Exit from the application programs and shutdown the system.
(2) Turn off the power of the server and disconnect all the power cords from the receptacles.
２．Installation procedure
(1) Check the position of the additional memory on the mother board.
Remove the top cover and check the memory connector on the mother board.
In that case, it may be necessary to remove a frame in addition to the top cover, or it may be
necessary to remove an option board. (Please refer to USER's GUIDE.)
(2) Install the DDR3-1600 REG Memory Kit
a. The lever on both sides of the DIMM socket is expanded right and left, and the memory dummy
is detached.
b. The memory card has cutouts to prevent incorrect insertion. Please orient the card so that the
connector polarity and card cutouts match.
c. Insert the card vertically on the connector. Press the levers at each end of the connector so
that they fasten the half-circle shaped cutouts on each edge of the card.
Caution
Since a memory card has unsymmetrical shape, please check the concavo-convex part of a
memory card and a connector, and mount it correctly.
Please exercise caution. Improperly fastened memory card can cause malfunctioning of the
main unit.
Front
Mother board
855-911106-589-00-1
Rear
Advertisement
