Oven Dimensions - Caple C2105SS Instruction Manual

professionally qualified person only.
The manufacturer declines all responsibility for
I N S T A L L A T I O N
any damage to persons, animals or materials due to incorrect installation.
Fitting the appliance
Fit the appliance into its surround (beneath a worktop or above
I M P O R TA N T :
another appliance) by inserting screws and plastic covers into the 2
ISOLATE YOUR OVEN FROM THE ELECTRICAL SUPPLY BEFORE PERFORMING INSTALLATION OR
holes (A - fig.3) that can be seen in the frame of the oven when the door
MAINTENANCE.
is open.
Installation should be carried out according to the instructions by a professionally qualified
person only.
For the most efficient air circulation, the oven should be fitted
The manufacturer declines all responsibility for any damage to persons, animals or materials due
according to the dimensions shown in fig. 1 & 2.
to incorrect installation.
The rear panel of the cabinet must be removed so that air can
circulate freely. The panel to which the oven is fitted should
have a gap of at least 70 mm at the rear for ventilation (fig.4 & fig.5).
F I T T I N G T H E A P P L I A N C E
See below for full dimensional drawings of your oven to help with
installation.
Fit the appliance into its surround (beneath a worktop
or above another appliance in a tall housing) by
inserting screws and plastic covers into the 2 holes
NOTE: where ovens are to be matched with hobs, it is essential
(A - fig.3) that can be seen in the frame of the oven
to follow the instructions contained in the manual supplied with
when the door is open.
the hob
For the most efficient air circulation, the oven should

Oven dimensions

be fitted according to the dimensions shown in
fig. 1 & 2.
The rear panel of the cabinet must be removed so that air can circulate freely. The panel to which
the oven is fitted should have a gap of at least 70mm at the rear for ventilation (fig.4 & fig.5).
Dimensions
Dimensions
Fig. 1
589mm
589mm
593mm
578mm
578mm
25mm
25mm
12 Instruction manual C2105SS
Please keep this instruction manual for future reference
Fig.2
Fig.3
Plastic cover
70mm
70mm Fig. 2
589mm
589mm
593mm
578mm
578mm
25mm
25mm
See below for full dimensional drawings of your oven to help with installation.
For a built-in oven to work well the cabinet must be of the right type.
The panels of the adjoining furniture should be heat resistant. Particularly when the adjoining
furniture is made of veneered wood, the adhesives should be able to withstand a temperature
of 120ºC. Plastic materials or adhesive which cannot withstand this temperature may become
deformed or unstuck.
To comply with safety regulations, once the appliance has been fitted it should not be possible to
make contact with the electrical parts.
All parts which offer protection should be fixed in such a way that they cannot be removed
without the use of a tool.
O V E N D I M E N S I O N S
595mm
593mm
593mm
20mm
5mm 5mm
540mm
565mm
Instruction manual C2105SS
Please keep this instruction manual for future reference
555mm
20mm
13