Using The Rotisserie - Caple C2105SS Instruction Manual

Using the Rotisserie

U S I N G T H E R O T I S S E R I E
Fig 6
Fig.6
The rotisserie function can be used in a number of programmes on this oven (see page 18.)
The rotisserie function can be used in a number of programmes on this oven. After fitting the food on to the spit (S),
After fitting the food on to the spit (S), block it with the two forks (F). then proceed as follows:
block it with the two forks (F). then proceed as follows:
» Position the spit support as shown in (fig. 6)
» Fit the end of the spit into the motor M at the back of the oven.
- Fit the knobs protection as shown in (fig. 6)
» Fit the support into the circular groove in the spit.
- Position the spit support as shown in (fig. 6)
» Unscrew and remove handle A.
» Place the oven tray with a little water on the lowest shelf of the oven.
- Fit the end of the spit into the motor M at the back of the oven.
» Close the oven door.
- Fit the support into the circular groove in the spit.
» When the cooking time is up, screw the handle on the spit and remove
everything from the oven. If necessary, use an oven glove to avoid any burns.
- Unscrew and remove handle A.
- Place the oven tray with a little water on the lowest shelf of the oven.
- Partially close the oven door.
- When the cooking time is up, screw the handle on the spit and remove everything from the oven. If necessary,
use an oven glove to avoid any burns.
20 Instruction manual C2105SS
Please keep this instruction manual for future reference
on the frame (see Fig.1).
- Secure the two side racks with the guide rails using the holes provided on the
T E L E S C O P I C R U N N E R S
oven walls (see Fig. 3).The holes for the left rack are situated at hole F1, F2 and
the right rack at hole D1, D2.
To assemble the telescopic runners:
Telescopic runners
- Finally, re-fit the side rack
To assemble the telescopic runners:
» Remove the side racks
- Remove the side racks
» Choose which shelf to use with the telescopic runner. Pay
- Choose which shelf to use with the telescopic runner. Pay attention to the
direction in which the runner is to be extracted, position joint 'B' and joint 'C'
attention to the direction in which the runner is to be extracted,
on the frame (see Fig.1).
position joint 'B' and joint 'C' on the frame (see Fig.1).
- Secure the two side racks with the guide rails using the holes provided on the
» Squeeze the bars together slightly and clip either end of the
oven walls (see Fig. 3).The holes for the left rack are situated at hole F1, F2 and
the right rack at hole D1, D2.
telescopic runners onto the side racks.
- Finally, re-fit the side rack
» Finally, re-fit the side racks as per below.
Side racks and Catalytic liners
A
To install, align the 2 holes in the catalytic liners with the 2 steel clips in the side of
S I D E R A C K S A N D C ATA LY T I C L I N E R S
the oven cavity. Once aligned, attach side racks by pushing these onto the furthest
To install, align the 2 holes in the catalytic liners with the 2 steel clips in the side of the oven
steel clip and then clicking the other end onto the closest steel clip.
cavity. Once aligned, attach side racks by pushing these onto the furthest steel clip and then
Side racks and Catalytic liners
clicking the other end onto the closest steel clip.
This will secure the catalytic liners to the sides of the oven. To remove, unclip the side
To install, align the 2 holes in the catalytic liners with the 2 steel clips in the side of
This will secure the catalytic liners to the sides of the oven. To remove, unclip the side racks from
the oven cavity. Once aligned, attach side racks by pushing these onto the furthest
racks from the side of the oven, and remove the catalytic liners.
the side of the oven, and remove the catalytic liners. steel clip and then clicking the other end onto the closest steel clip.
This will secure the catalytic liners to the sides of the oven. To remove, unclip the side
Visit our Caple website to view a 'How to video' on this. www.caple.co.uk
Visit our Caple website to view a 'How to video' on this. www.caple.co.uk
racks from the side of the oven, and remove the catalytic liners.
Visit our Caple website to view a 'How to video' on this. www.caple.co.uk
Fig.1
Fig.1
Instruction manual C2105SS
Please keep this instruction manual for future reference
Fig 1.
Fig 2.
21