Type M148: Moving the hinge brackets to the...
3.
2.
Fig. 5
7.
5.
4.
Fig. 6
9.
Fig. 7
2.
8.
(cont.)
02. Remove split pin and pull out bolt.
03. Remove eye screw.
04. Insert eye screw until it sits behind the joint piece.
05. Screw on the nut and slot the washer on.
06. Continue inserting eye screw through hole.
07. Mount washer and screw on nut (washer and nut
are supplied with the hinge).
08. Insert bolt.
09. Tighten nuts (approx. 100 Nm).
Secure bolt with split pin.
10. Repeat steps 1 to 9 for the lower fitting.
9