Terminal Emulator Display Settings; Terminal Emulator Connection Settings; Connecting A Usb Cable To The Cli Port - Lenovo ThinkSystem DS Series Hardware Installation And Maintenance Manual

Within the illustration below, the IOM is aligned for use in the bottom (0B) controller module slot in a 2U
enclosure.
Figure 68 Connecting a USB cable to the CLI port
4. If using a mini-USB cable, enable the CLI port for subsequent communication.
Linux customers should enter the command syntax provided in

(page
Windows customers should locate the downloaded device driver described in

download" (page
5. Start and configure a terminal emulator, such as HyperTerminal or VT-100, using the display settings used in
Table 11 (page
Table 11 Terminal emulator display settings
Parameter
Terminal emulation mode
Font
Translations
Columns
Table 12 Terminal emulator connection settings
Parameter
Connector
Baud rate
Data bits
Parity
Stop bits
Flow control
1-Your server or laptop configuration determines which COM port is used for Disk Array USB Port.
2-Verify the appropriate COM port for use with the CLI.
6. In the terminal emulator, connect to controller A.
82 Installation
155).
154), and follow the instructions provided for proper installation.
82), and the connection settings in
Value
VT-100 or ANSI (for color support)
Terminal
None
80
Value
COM3 (for example)
115,200
8
None
1
None
"Setting parameters for the device driver"
Table 12 (page 82) (See the note following this procedure).
1,2
"Obtaining the software