Care And Maintenance; Recurrent Maintenance; Cleaning Of Metal Parts; Cleaning Of Ceramic Glass - Caminetti Montegrappa TECH 3 Directions For Installation, Use And Maintenance

4 CARE AND MAINTENANCE
4.1 Recurrent maintenance
Do not forget that performing the following recurrent maintenance will ensure your appliance efficiency and proper operation for a long
time.
WARNING: All cleaning of the various parts must be done when the appliance is completely cold and disconnected
from the electrical power source (electronic control unit switch in OFF position).
4.1.1 Cleaning of metal parts
Clean with a dry, soft cloth; do not use any detergent or cleaning products.
4.1.2 Cleaning of ceramic glass
To perform if needed.
The quality and type of fuel as well as the way of use can
determine the frequency of cleaning the ceramic glass.
Minor soot may accumulate due to incorrect combustion (an
insufficient combustion air, a poor draught or the use of wet
firewood pieces); the glass panel may self-clean satisfactorily
under the restored good operational conditions.
1. In order to carry out the cleaning operations the side glasses need to be
opened using the allen key supplied. Pull out the two side latches
placed in the upper and in the lower part.
2. Using the allen key hook the two pins in the upper and lower part of the
door frame, then pull; thereafter proceed with the normal cleaning
operations.
3. We recommend the use of our "Puliglass" glass cleaner for perfect
cleaning; spray some cleaner on a soft cloth to remove any tar and soot
stains from the glass.
TECH 3
ENGLISH
39