Troubleshooting - Hagerman Audio Labs FRYBABY2 Manual

FRYBABY2 Compact Burn-in Generator 5
Connections
The FryBaby2 is designed to burn-in and condition cables offline. It can also be used
as a signal generator to break-in amplifiers or other electronics.
RCA
The FryBaby2 can burn in a stereo pair of interconnects by using the female-to-
female adapter at the far end. First, do a voltage burn by connecting the
interconnect pair directly to the FryBaby2 outputs. Set to ON. After the voltage burn,
do a current burn by inserting the adapter to close the loop.
Phonostage, Linestage, Amplifier
Amplification electronics are burned in using voltage mode. Connect the FryBaby2
outputs to the inputs on your phonostage (you'll need an interconnect). Set the
output amplitude to either MC or MM, depending on the gain of your phonostage.
This sets the burn-in signal to the correct amplitude and equalization. For linestages
or other types of amplifiers, use the ON level output. Amplifier must be powered on.

Troubleshooting

If the LED is not lit, check the power supply and rotary switch.