ADEO SCREEN MULTIFORMAT Installation And Operation Manual page 15

ENGLISH – Rolling screen installation and operation manual
PROGRAMMING END STOPS FABRIC and MASK (procedures already carried out in factory, SHOULD NOT be performed by unauthorised personnel)
Each programming procedure consists of several steps; at the end of each step, the operator has 60 seconds to start the next step; this system is devised to prevent the risk of performing operations other
than those desired. Therefore, if the motor does not perform the operation exactly as indicated in the instructions, wait 60 seconds, then exit programming, or cancel the procedure as indicated at specific
point, and start the procedure all over again.
The motor's settings follow an overwriting logic: therefore, once the end stop positions have been memorised they cannot be cancelled, but only overwritten by following the above-mentioned procedure from
the start.
In order to cancel the procedure in course, simultaneously press  and  at any time, until the motor has executed 6 movements.
Made by Adeo Screen Sp. Z o.o. (Poland) Specifications are subject to change without notice. E&OE
Doc: MULTIFORMAT Installation Manual rev2 | 22.08.2018
Please verify that you are working with the latest revision of this document before specifying your screen.
END STOP MASK MOVEMENT (SHOULD NOT be performed by unauthorised personnel)
TO CANCEL THE PROGRAMMING IN COURSE
Page 15