Subscribe to Our Youtube Channel
Related Manuals for FarmTek 1020SPC
Summary of Contents for FarmTek 1020SPC
- Page 1 CANOPIES Sunblocker Shade House 10' Wide Photo may show a different but similar model. STK# DIMENSIONS ©2009 FarmTek® All Rights Reserved. Reproduction 1020SPC 10’ W x 20’ L is prohibited without permission. Revision date: 07.21.09...
-
Page 2: Safety Precautions
BEGIN TO ASSEMBLE THE SHELTER. • Never erect the structure under power lines. Thank you for purchasing this FarmTek® shelter. When • Identify whether underground cables and pipes are properly assembled and maintained, this product will present before preparing the site or anchoring the provide years of reliable service. -
Page 3: Assembly Procedure
These words and phrases are common to most joints and to fasten brackets to rafters. FarmTek® shelters and identify the different parts of the shelter. (Some are used in this document. Others may not apply to this particular shelter.) These terms describe the shipped parts and can also be found on the materials list/spec sheets included with the shipment. -
Page 4: Required Tools
CANOPIES REQUIRED TOOLS The following list identifies the main tools needed to Space below is reserved for customer notes. assemble the shelter. Additional tools and supports may be needed depending on the structure, location, and application. • Tape measure or measuring device •... - Page 5 CANOPIES The following graphics and photos will help you identify the different parts and show you how they are used. (Some parts are not shown.) 102192 CC4595 102191 Tie Down 8'' Snugger Ball 3-Way Coupler 4-Way Coupler ADDITIONAL PARTS IDENTIFICATION NOTES In some instances, there can be differences between the parts that are shown and referenced in the instructions and the parts that are shipped with the shelter.
- Page 6 CANOPIES Sunblocker Shade House ATTENTION: Customer can assemble frame as desired. One suggested method is to assemble the entire roof section of the shelter first. The frame is ASSEMBLE THE MAIN FRAME then lifted and the legs added. This section is an overview of the process for assembling your roof frame.
- Page 7 CANOPIES INSTALL THE MAIN COVER After assembling the main frame, install the main frame cover. Gather the parts: • Snugger ball tie downs (#CC4595) • Main cover and side panels (if equipped) NOTE: Assistance is required to assemble the shelter. 1.
-
Page 8: Care And Maintenance
Never pack the covers when they are wet. Always dry them before you pack the shelter. • For replacement or missing parts, call 1-800-245-9881 for assistance. NOTE: With the exception of Truss Arch buildings, FarmTek® shelters and greenhouses do not have any tested loading criteria. Revision date: 07.21.09... - Page 9 CANOPIES 8'-10 5/8" Height QUICK START GUIDE 10' Wide Sunblocker Shade House 5'-7 7/8" Sidewall Height 10'-5 3/4" Width FRONT Grid Represents 12" Squares Revision date: 07.21.09...
- Page 10 CANOPIES Revision date: 07.21.09...
- Page 11 CANOPIES Revision date: 07.21.09...
- Page 12 CANOPIES Revision date: 07.21.09...
- Page 13 CANOPIES Space below is reserved for customer notes. Revision date: 07.21.09...
Need help?
Do you have a question about the 1020SPC and is the answer not in the manual?
Questions and answers