BEGIN TO ASSEMBLE THE SHELTER. • Never erect the structure under power lines. Thank you for purchasing this FarmTek® shelter. When • Identify whether underground cables and pipes are properly assembled and maintained, this product will present before preparing the site or anchoring the provide years of reliable service.
These words and phrases are common to most FarmTek® shelters and identify the different parts of the shelter. (Some are used in this document. Others may not apply to this particular shelter.) These terms describe the shipped parts and can also be found on the materials list/spec sheets included with the shipment.
QUICK START DIAGRAMS For a quick overview of the shelter and its components, consult the Quick Start diagrams at the back of these instructions. Continue with FRAME ASSEMBLY procedures that follow. Visit www.FarmTek.com for additional products and customer assistance.
Page 5
(Not all parts are shown.) 100441 FA4482B Nut Setter Tek screw 104656 104653 104654 Elbow Coupler 4-Way Coupler 3-Way Coupler CC4595 QH1070 102205 Tie Down 8'' Snugger Ball Tee Coupler Pipe Strap Visit www.FarmTek.com for additional products and customer assistance.
Page 6
WARNING: To prevent personal injury and damage to the shelter, a Tek screw must be installed and tightened at each pipe and coupler joint. To prevent cover damage, install the Tek screw so that it does not touch the main cover or any optional side or end panels. Visit www.FarmTek.com for additional products and customer assistance.
Page 7
4. Continue with assembling the main roof frame. 4. Once all the legs are assembled and set to the side, continue with locating the purlin pipes. Visit www.FarmTek.com for additional products and customer assistance.
Page 8
ATTENTION: Position Tek screws so they will not touch the main covers or side panels (if equipped) when these are installed. Purlins Rafters Frame length shown may differ from actual frame. Visit www.FarmTek.com for additional products and customer assistance.
Page 9
6. After anchoring the frame, continue with attaching the necessary (or rotate the pipes) and remove or tape any main cover. sharp edges. Legs Width Length NOTE: Frame length shown may differ from actual frame. Visit www.FarmTek.com for additional products and customer assistance.
Page 10
(QH1070) attach the upper-back purlin to the building to secure the frame. (See arrows above for location.) 4. Continue with the side panel installation (if equipped), or read the shelter care and maintenance information that follows. Visit www.FarmTek.com for additional products and customer assistance.
For replacement or missing parts, call 1-800-245-9881 for assistance. NOTE: With the exception of Truss Arch buildings, FarmTek® shelters and greenhouses do not have any tested loading criteria. 5. After all panels are installed, read the shelter care and maintenance information that follows.
Page 12
QUICK START GUIDE 12' Wide Attached-Style Awnings 12'-0" FRONT Grid Represents 12" Squares 104400 (12' X 10') 104401 (12' X 15') 104402 (12' X 20') 104403 (12' X 25') 104404 (12' X 30') Visit www.FarmTek.com for additional products and customer assistance.
Page 13
WEATHERSHIELD AWNINGS Visit www.FarmTek.com for additional products and customer assistance.
Page 14
WEATHERSHIELD AWNINGS Visit www.FarmTek.com for additional products and customer assistance.
Page 15
WEATHERSHIELD AWNINGS Visit www.FarmTek.com for additional products and customer assistance.
Page 16
WEATHERSHIELD AWNINGS Visit www.FarmTek.com for additional products and customer assistance.
Page 17
WEATHERSHIELD AWNINGS Visit www.FarmTek.com for additional products and customer assistance.
Page 18
WEATHERSHIELD AWNINGS Visit www.FarmTek.com for additional products and customer assistance.
Page 19
WEATHERSHIELD AWNINGS Visit www.FarmTek.com for additional products and customer assistance.
Page 20
WEATHERSHIELD AWNINGS Visit www.FarmTek.com for additional products and customer assistance.
Page 21
WEATHERSHIELD AWNINGS Space below is reserved for customer notes. Visit www.FarmTek.com for additional products and customer assistance.
Need help?
Do you have a question about the 104400 and is the answer not in the manual?
Questions and answers