Advertisement
AUTOMATIC mode:
In automatic mode the NJ164 runs through all its
programs. To select Automatic mode press the MODE
button for >2 seconds and release, and repeat this until
is shown in the display.
AUT
At this point, the run time, speed and flash time can be
set. Press the MODE button for <1 second to select
which function is to be adjusted.
selects the run time. Press the INCREASE or
n.--
DECREASE buttons to select the required run time.
selects the speed. Press the INCREASE or
S.--
DECREASE buttons to select the required speed.
selects the speed. Press the INCREASE or
F.--
DECREASE buttons to select the required flash time.
SLAVE mode:
A luminaire in slave mode copies the functions of a
luminaire to which it is connected by DMX. If there is
only ONE luminaire in use, DO NOT select slave mode.
To select slave mode, press press the MODE button for
>2 seconds and release, and repeat this until
shown in the display.
Built-in programs:
In this mode, it is possible to select the program, and for
some programs it is possible to select the colours.
To select slave mode, press the MODE button for >2
seconds and release, and repeat this until
the first digit of the display.
At this point, the program, run time, speed and flash
time can be set. Press the MODE button for <1 second
Page 5
SLA
is shown in
P.
is
Advertisement
