Poe Alive Check Configuration - Planet HPOE-1200G User Manual

4.5.5 PoE Alive Check Configuration

The HPOE-1200G/2400G and POE-1200G/2400G PoE Switch can be configured to monitor connected PD's status in
real-time via ping action. Once the PD stops working and without response, the HPOE-1200G/2400G and
POE-1200G/2400G PoE switches are going to restart PoE port power, and bring the PD back to work. It will greatly
enhance the reliability and reduces administrator management burden.
This page provides you how to configure PD Alive Check as the screen in Figure
The page includes the following fields:
Object
 Mode
 Remote PD IP Address
 Interval Time (10~300s)
 Retry Count (1~5)
 Action
User's Manual of POE-1200G / POE-2400G / HPOE-1200G / HPOE-2400G
Figure 4-15-14: PD Alive Check Configuration Screenshot
Description
Allows user to enable or disable per port PD Alive Check function. All ports are
disabled as default value.
This column allows user to set PoE device IP address here for system making ping
to the PoE device. Please note that the PD's IP address must be set to the same
network segment as the HPOE-1200G/HPOE-2400G PoE switch.
This column allows user to set how long system should issue a ping request to PD
for detecting whether PD is alive or dead. Interval time range is from 10 seconds to
300 seconds.
This column allows user to set how many times system wants to retry ping to PD.
For example, if we set count 2, the meaning is that if system retry ping to the PD and
the PD doesn't response continuously, the PoE port will be reset.
Allows user to set which action will be apply if the PD is without any response. The
HPOE-1200G/HPOE-2400G PoE Switch offers 3 actions as follows:
 PD Reboot: It means system will reset the PoE port that is connected to the
PD.
 Reboot & Alarm: It means system will reset the PoE port and issue an alarm
message via Syslog, SMTP.
4-15-14
52
appears.