Checking The Battery Charge Level; Changing Tools; Torque Selection Ring/Drill Setting; 2-Speed Gearbox - Parkside PABS 20-Li D5 Translation Of The Original Instructions

Checking the battery charge level

♦ To check the battery status, press the battery
charge level button 6 (see fig . E) . The status/
remaining charge is shown on the battery
display LED 7 as follows:
GREEN/RED/ORANGE = maximum charge/
performance
RED/ORANGE = medium charge/performance
RED = low charge – charge the battery

Changing tools

Your cordless screwdriver has a fully automatic
spindle lock .
When the motor is at a standstill, the drive train is
locked so that you can open the drill chuck q by
turning it . After you have inserted the desired
tool and clamped it by turning the drill chuck
you can resume working immediately (see fig . F) .
The spindle lock is released automatically when
the motor is started (by pressing the ON/OFF
switch 4) .

Torque selection ring/drill setting

You can set the torque using the torque preselec-
tion ring w (see fig . G) .
♦ Select a low level for small screws or soft
materials .
♦ Select a high level for large screws, hard
materials or for removing screws .
♦ For drilling operations, select the drill setting by
moving the torque preselection ring w to the
position .

2-speed gearbox

CAUTION!
► Operate the speed selector switch 1 only
when the appliance is at a standstill . Other-
wise the appliance could be damaged .
In first gear (speed selector switch 1 in
position 1)
you can reach a speed of approx . 400 rpm and
a high torque . This setting is suitable for all screw-
driving jobs .
■ 8 │ GB │ IE │ NI
In second gear (speed selector switch 1 in
position 2)
you can reach a speed of approx . 1400 rpm for
carrying out drilling work .

Changing cutter knife blade

♦ Break the blunt section of the blade off at the
defined breaking point using a pair of pliers .

Use

Switching on/off

Switching on
♦ Press and hold the ON/OFF switch 4 to start
up the appliance .
The LED work light 0 lights up when the ON/
,
OFF switch 4 is pressed slightly or fully, and
illuminates the working area in low light condi-
tions .
Switching off
♦ Release the ON/OFF switch 4 to switch off the
appliance .

Setting the rotational speed

The ON/OFF switch 4 has a variable speed con-
trol . Pressing the ON/OFF switch 4 yields a low
speed . Increasing the pressure increases the speed .
NOTE
► The integrated motor brake ensures that the
appliance stops quickly .

Changing the direction of rotation

♦ Change the direction of rotation by pushing the
rotation direction switch 3 to the right or left .
PABS 20-Li D5