Welcome; Adjusting The Carrying Handle - Agilent Technologies E4417A Installation Manual

Peak and average power meters

Hide thumbs Also See for E4417A:

Table of Contents

)GVVKPI 5VCTVGF

9GNEQOG

Welcome to the Agilent Technologies E4416A and E4417A EPM-P series peak

and average power meters Installation Guide. This guide shows you how to:

• physically check the power meter

• adjust the carrying handle

• switch it on

• confirm the meter passes the power on self test

• connect it to a power sensor

• carry out a zero and calibration routine

• make connections to the rear panel

• configure the remote programming interfaces

• attach the rack mounting kits (supplied with option 908 or option 909)

N O T E

Both single and dual channel power meters with variety of rear panel

configurations have been used for the illustrations in this guide. Your power

meter may differ in detail to those shown.

+PKVKCN +PURGEVKQP

Please inspect the shipping container for damage. If the shipping container or

packaging material is damaged, it should be kept until the contents have been

checked mechanically and electrically. If there is mechanical damage, notify the

nearest Agilent Technologies office. Keep the damaged shipping materials (if

any) for inspection by the carrier and an Agilent representative. If required, you

can find a list of Agilent Sales and Service Offices on page 44.

Before continuing, please ensure you have read and understood the preceding

safety information.

Table of Contents

Epm-p series E4416a