Brinsea Chick Safe eco Installation And Operating Instructions

 Important! Install the ChickSafe Eco and attach the door BEFORE installing batteries.
Failure to observe this may cause incorrect operation and possible damage.
 The ChickSafe is supplied pre-set to be attached to a FULLY OPEN DOOR. Failure to
observe this will cause incorrect operation and possible damage.
Please read these instructions carefully before setting up your ChickSafe Eco to achieve best results and keep these
instructions safe for future reference.
To register your new Brinsea product and qualify for your free 3 year warranty please visit www.brinsea.com within
30 days of purchase and follow the link on the Brinsea home page. The serial number may be found on the box
and inside the battery compartment. Sign up for the Brinsea newsletter to receive the latest news and information.

Warning - Risk of injury! Keep fingers clear of moving door and cord. Motor may start without warning.

Ensure the maximum door weight of 8lbs (4kg) is not exceeded as this will cause damage to the motor
and invalidate the warranty! Note that wooden doors are heavier when wet.

The maximum door lifting height is 15" (400mm). Do not exceed this as operation will be incorrect and
the cord may become detached.

Check the sliding door to make sure it runs smoothly and reliably both upwards and downwards. The
ChickSafe uses gravity alone to close the door.

To mount the ChickSafe further away from the door, an additional length of cord may be attached. For
helpful information see our ChickSafe 'Frequently Asked Questions' page at www.brinsea.com

This appliance can be used by children aged from 8 years and above and persons with reduced physical,
sensory or mental capabilities or lack of experience and knowledge if they have been given supervision
or instruction concerning use of the appliance in a safe way and understand the hazards involved.
Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children
without supervision.
Tools needed for installation:
- Screwdriver (cross head PZ1)
- Drill with a 1/8" (3mm) diameter
drill bit, or bradawl
- Tape measure
Caution! - Please Note:
•
Use only alkaline AA batteries
•
Observe correct polarity to
prevent leakage or risk of fire
•
Do not mix old and new
batteries
D
•
Do not use re-chargeable
batteries
•
Do not use a 9 volt battery
•
Remove the batteries if you do
not intend to use the ChickSafe
Eco for a long period.
1
A A
Raise the sliding door to its fully
open position.
Support the door in that
position.
Once fitted, the ChickSafe will
always open the door to this
height. Make sure it is correct.
1
Installation and
Operating Instructions
(See page 3).
(See page 3).
2
4 3/4"
121mm
1/8" (3mm)
Mark two hole positions 4 ¾"
(121mm) apart and approximately
6 ½" (170mm) above the top of the
sliding door.
Make sure they are level and evenly
spaced above the centre of the door.
Make the holes with a 1/8" (3.0mm)
drill bit or bradawl.
CS010 US Issue 01