Pairing - Encoding Transmitter (Collar) With Receiver (Handset); Pairing - Encoding Another Receiver (Handset) With Your Receiver - Dog trace X30T Operating Manual

1
* Setting only applies to the X30B/X30TB transmitters
** Displayed when Boar Mode is set (
7.5 Pairing – encoding transmitter (collar) with receiver (handset)
1. Turn on the receiver and transmitter you wish to pair together – switch other
devices off.
2. Hold the CODE push button on the receiver for 2 seconds.
3. Select the position to which you wish to pair the transmitter (collar) by using
arrows. If the position is empty (there is no paired transmitter, receiver or saved
waypoint), the
4. Hold the CODE push button again for 2 seconds.
5. Move the transmitter close to the receiver with the RF aerials parallel to each
other.
6. After pairing, the
is lit on the display (according to the selected position to which the transmitter is
paired).
7. If you wish to pair another transmitter, repeat the procedure from Point 3.
8. To exit the coding mode press
NOTE: To delete one of the paired transmitters (collars), receivers or waypoints
from the receiver's memory, carry out pairing without the transmitter turned on.
After approximately 20 seconds, the
position.
NOTE: The receiver X30/X30+ is possible to pair with X20/X20+ transmitters
(collars). It is not possible to send training commands to these collars. Some other
functions are limited.
7.6 Pairing – encoding another receiver (hand set) with your receiver
DOG GPS X30 enables pairing of other dog handlers' receivers with your receiver
and then track their position. Updating the position of other dog handlers in your
receiver takes place every 60 seconds.
Turn on another receiver to transmit its position before pairing your receiver with
this receiver commences.
14
2 3
/
/
–
/ /
/
/
)
message is shown on the display.
message is displayed and
.
4 5
message appears at the given
Chapter
9 .1
7 .6
6 .4
7 .9
8 .7
/
to