Technical Data; Assembly Site; Safety Instructions - Barthelme CHROMOFLEX PRO Series Instruction Manual

3. TECHNICAL DATA

Operating voltage: 8 V DC to 26 V DC
Protection class: III
Output current 4 channels: max. 4 A / channel
Output current 3 channels: max. 5 A / channel
Output current 2 channels: max. 5 A / channel
Output current 1 channels: max. 8 A / channel
Dimensions (L/W/H): 116 / 52 / 22 mm
Current consumption of one unit (without LED): about < 5 mA
Ambient temperature: 0°C ~ +50°C
(in dry conditions only with sufficient air circulation for heat dissipation, non-condensing)
Radio frequency: 2.4 GHz
Manufacturer: Josef Barthelme GmbH & Co. KG

4. SAFETY INSTRUCTIONS

The modules might produce some heat. Care must be taken to provide unrestricted air
ventilation.
The unit is equipped with a limited protection against reverse polarity. Connecting the
power in reverse polarity can destroy the module, even if connected for a short time only.
Important: It is guaranteed by design that the units will never generate any higher voltage
than the supply voltage. The module is the ideal solution for use in low-voltage areas, like
pools, steam baths, SPAs, etc.
Electronics must not be modified. Observe the official regulations for electrical devices
(like DIN, VDE, EN), especially when LEDs are used in wet areas!
This product is not a toy, keep away from children!
We decline any liability, loss or damage caused by improperly used modules! Guarantee
is also lost in such cases.
LEDs can get quite hot. We strongly recommend ensuring maximum operating temperature
is not exceeded, because this might reduce the expected life time of the LEDs significantly.
WARNING 1:
LED light may have very high intensity even when dimmed. Some modern LEDs are classified
by the lasers marking obligation. Particularly in connection with optics also weak LEDs may be
very dangerous. Staring into LEDs may cause irreparable damage to the eye's retina. Hence:
NEVER STARE INTO THE BEAM. Use diffusers to spread the intensity!
WARNING 2:
Please be aware of the fact that LED light may cause side effects. This light changes intensity
very fast! Changing light may affect the perception and is also known to trigger epileptic seizu-
res in persons who are photosensitive.
5. MONTAGE
The electric wiring/connection must comply with all current and valid national requirements,
be constructed by a certified electrical tradesman, and, comply with all the requirements set
forth in this planning manual. Connection scheme see chapter 6.1.
ATTENTION: Disconnect the system and the device before doing any work!

ASSEMBLY SITE

The unit is suitable for floor-,wall- and ceiling assembly.
Make sure that the unit is mounted on a stable, plain, non-tilting base. In operation the unit
might produce heat. Care must be taken to provide unrestricted air ventilation.
FIG.: 1
Dimensions/Mounting holes
6. CONNECTION
IMPORTANT:
The module must be operated with a power supply that is suitable for the used LEDs!
IMPORTANT:
Improper power supplies may lead to malfunctions, unwanted flickering effects, overheating,
destruction of LEDs or destruction of electronics.
We strongly recommend using high-quality (stabilized) switching power supplies!
We warn against using non-stabilized power supplies. We recommend switching pow-
er supplies. Even LED power supplies are not recommended, because some are already
equipped with control electronics for constant current, which will destroy the electronics of
CHROMOFLEX Pro Bluetooth 4.0.
88.6
116