On this surface you can adjust the color of the
connected LEDs, as well as the white portion
of RGBW tapes and spots.
The three points in the upper right corner can
be used to call up additional settings.
Click the „Disconnect" button to disconnect
the currently selected CHROMOFLEX Pro Blue-
tooth 4.0.
Use „App Settings" to change the settings of
the app installed on your smartphone.
„Device settings" allows you to change the sto-
red attributes of the device connected to your
smartphone.
The "Switch layout" button allows you to
switch from the Ring Slider view („HSVW") to
the Vertical Slider view („RGBW"). In addition,
all stored automatic color programs can be
started via „Automatic Programs".
The „About" section shows the current version
of the app.
Bluetooth 4.0
White
Saved.: ON
State: ON
Bluetooth 4.0
Disconnect
App Settings
Device Settings
Switch layout
About
White
Saved.: ON
State: ON
The two lower buttons „Saved:" and „State:"
can be used to switch off and on the device,
additionally a light value can be stored here
and recalled as required.
Press and hold the „Saved:" button to save the
currently set color value. Now the color set-
tings can be changed as desired, and the sto-
red value is called up again when the „Saved:"
button is pressed again.
In addition, the stored color is defined as the
start color. When the primary voltage is taken
from the device and reconnected, the device
starts with the start color.
DIFFERENT LAYOUTS:
RGBW (HSVW)
RGB (HSV)
RGB
CONTROLLED WHITE
Bluetooth 4.0
White
Saved.: ON
State: ON
RGBW
1-CHANNEL