Advertisement
EN
|
Troubleshooting guide
Problem
Solution
The appliance doesn't
Turn the bowl or lid or the blender jar clockwise until
go on
you hear a click. Check if the screw cap has been
correctly assembled on the motor housing when the
blender is not used. Make sure that the dots indicated
on the bowl and lid are directly opposite each other
and the dot on the bowl is directly opposite the dot
on the motor housing. In case the blender is attached,
make sure the rib on the blender jar is directly
opposite the print on the motor housing.
Both the blender jar
If both the blender jar and the food-processing bowl
and the food
have been mounted correctly, only the blender will
processing bowl are
work. If you want to use the food-processing bowl,
attached, but only the
remove the blender jar and assemble the screw cap.
blender works.
The appliance
The thermal safety cut-out has probably cut off the
suddenly stopped
power supply to the appliance because it has
running
overheated. 1) Unplug the appliance. 2) Turn the
control knob to 0. 3) Let the appliance cool down for
60 minutes. 4) Put the mains plug in the socket. 5)
Switch the appliance on again.
The kneading or
Check if you have really turned the bowl and the lid
balloon beater doesn't
clockwise as far as the point where you hear a click.
turn.
The meat looks as if it
Check whether the cutting edges of the cutter unit
has been 'pressed
are pointing outwards.
through' rather than
minced.
The meat mincer
Make sure the gear housing and the cutter housing
does not work.
have been assembled correctly.You will hear a click
when they have been fastened properly.
The metal parts of
The parts have been cleaned in the dishwasher.You
the meat mincer look
should clean all parts by hand and dry them
rusty.
immediately with a tea towel.!
Problem
Solution
Can I also mince
No!
bones or bacon rind
with the meat mincer?
Is it possible to mince
No!
frozen meat with the
meat mincer?
PL
|
Essence
59
Advertisement
