Verasys LC-VAC3000-0 Quick Start Manual

Verasys Boiler Controller
Quick Start Guide
LC-VAC3000-0
Figure 1:

About this guide

This quick start guide provides the basic information you need to
configure and install the Boiler Controller and application.
For further information, refer to the Verasys® 32 Point 24 VAC
Application Controller Installation Instructions (24-10143-01515), and
Verasys Boiler Controller Application Note (LIT-12013275) on
QuickLit.
For more information or to access Quicklit, scan the following QR
codes:
LC-VAC3000-0 QR code
Refer to the QuickLIT website
LC-VAC3000-0
QuickLit QR code
Verasys Boiler Controller Quick Start Guide
for the most up-to-date version of this document.

Mounting the controller

To mount the controller, complete the following steps:
1. Mount a 20 cm (8 in.) section of 35 mm (1.3 in.) DIN rail
horizontally.
Note: Mount the controller in the horizontal position.
2.
On the back of the controller, extend the two mounting clips as
shown in the following figure.
Figure 2: Pull lower mounting clips down
3. Place the controller on the DIN rail.
4. To secure the controller on the DIN rail, push the bottom
mounting clips up as shown in the following figure.
Figure 3: Pull lower mounting clips down
5. To remove the controller from the DIN rail, pull the bottom
mounting clips out to the extended position and carefully lift the
controller off the DIN rail
1
Code No. Lit 12013353
Issued June 2019