PEGAS CRAFTAP SMART Manual page 9

CRAFTAP SMART | Service Manual
11
Remove the plate from the drip tray. Twist off the
sleeve of filling head, disconnect the gasket, remove
the seal out of the groove, and the seal out
of the hole. Wipe disassembled parts with a sponge
deeped into warm water with a neutral detergent.
12
Wipe the inner surface of the flask with a sponge
deeped warm water with a neutral detergent.
Then wipe inner and outside surfaces with
clean wet cloth. Then wipe the flask dry with
a lint-free cloth.
Before dispensing
Drain water left in the beverage supply line in an empty transparent container of the maximum volume suitable
for the device. Dispense according to instructions in Dispensing manual. Drain the remained liquid until beer
comes into the container.
Then stop dispensing by short pressing
of any button "1", "2" or "3".
Manual videos can be found on http://beerinnovations.com
Wash up all the parts with running water
and wipe them dry with a clean lint-free
cloth. Assemble in backward order.
13
To keep cleanliness till the next usage of the device
do not pour water used for washing at the final
stage out of the beverage supply line. Connect
the intake cap removed from the washing keg
to the beer keg.
Do not forget to close the door
of the device before dispensing.
7