Adjusting Forks; Removing/Installing Castor Assemblies; Removing Front Wheels; Installing Front Wheels - Invacare Action3 NG RC Service Manual

2.6 Adjusting Forks

WARNING
Risk of wobbling castors
Caster angle vertical axis MUST be at 90° +/- 1° from the ground. Both castor assemblies
should be at the same angle.
After ANY adjustments, before use, make sure all attaching hardware is tightened securely
- otherwise injury or damage may occur.
NOTE: For this procedure, refer to sections Adjusting Castor Angle and Adjusting Castor Assembly
Position, in the ordinary Action3 NG Service Manual.
2.7 Removing/Installing Castor
Assemblies
NOTE: If replacing a front castor note the mounting
position of the existing front castor for installation of
the new front castor.
NOTE: Both front castors MUST be the same size
and adjusted to the same height.
NOTE: For this procedure, refer to Seat-to-floor
heights table in the ordinary Action3 NG Service
Manual.

2.7.1 Removing Front Wheels

NOTE: For this procedure, refer to FIGURE 2.6.
1. Remove the mounting bolt, axle spacers (if present) and locknut that secure the front
wheel to the fork.
2. Remove the wheel from the fork.

2.7.2 Installing Front Wheels

NOTE: For this procedure, refer to FIGURE 2.6.
1. Using the mounting bolt, axle spacers (if present) and locknut, secure the wheel to the
desired wheel mounting position.
2. Ensure fork stem is perpendicular to the flat surface.
.
60122664-A
FIGURE 2.6
11