Philips FC8257/01 User Manual page 10

Electronic suction power control, combination nozzle
Hide thumbs Also See for FC8257/01:
Table of Contents

Advertisement

English
10
Environment
-
Do not throw away the appliance with the normal household waste at the end of its life, but
hand it in at an official collection point for recycling. By doing this, you help to preserve the
environment (Fig. 30).
guarantee and service
If you need service or information or if you have a problem, please visit the Philips website at
www.philips.com or contact the Philips Consumer Care Centre in your country (you find its phone
number in the worldwide guarantee leaflet). If there is no Consumer Care Centre in your country,
go to your local Philips dealer.
The storage box is not covered by the terms of the international guarantee.
troubleshooting
This chapter summarises the most common problems you could encounter with the appliance. If
you are unable to solve the problem with the information below, contact the Consumer Care
Centre in your country.
1
The suction power is insufficient
-
Perhaps the dust container is full.
If necessary, empty the dust container.
-
Perhaps the filters need to be cleaned or replaced.
If necessary, clean or replace the filters.
-
Perhaps the suction power slide on the handgrip is open.
Close the slide.
-
Perhaps the electronic suction power control (specific types only) has been set to a low setting.
Set the control to a higher setting.
-
Perhaps the nozzle, tube or hose is blocked up.
-
To remove the obstruction, disconnect the blocked-up item and connect it (as far as possible)
the other way round. Switch on the vacuum cleaner to force the air through the blocked-up
item in opposite direction (Fig. 31).

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents