Table of Contents
Advertisement
Available languages
Available languages
•
Fix now the receiver with double-sided tape or cable straps under the cover. Screw the holder for the antenna pipe
to the radio plate 532005 and lead the antenna cable through (see the following illustration).
•
Finally fasten the electronic speed control with double-sided tape or tie-wrap to the radio plate.
•
Now you can plug the individual components together. Set now (if not happened yet) the electronic speed controller
as per manual and the straight line guidance of the vehicle with the steering trim knob (see page 2).
YOUR ASSEMBLED VEHICLE SHOULD LOOK THIS WAY
The Radicator is equipped with module 0,6. If you want to change the gear ratio of the vehicle, use pinions with the
module 0,6 (stock no.: 93808.XX). A smaller pinion produces more acceleration, a larger more top speed.
SERVICE
In addition to the already described service work should always try your vehicle in order to prevent wear. If dirt gets in
moving parts, this affects the performance of the model signifi cantly. Remove dirt or dust with compressed air, a soft
brush and / or with a toothbrush. If possible, try using no solvents, as this is in fact the dirt in the camps and in the nor-
mally inaccessible places and thus cause additional wear. We recommend the following simple procedures:
•
Remove dirt and dust as far as possible with the methods described above.
•
Check the car on worn, broken or gripping parts and repair them if necessary.
•
Check regularly the fi xed seating all screws and tighten them if necessary.
Service and repair
In problem cases, or for questions and repairs, please contact:
GRAUPNER-Service, Henriettenstrasse 94-96, D-73230 Kirchheim/Teck,
Tel. +49/1805/472876
GM-Racing 90500 - 90500.RTR Radicator 4WD
08
Advertisement
Table of Contents
