DENTSPLY ECLIPSE 9494800 Owner's/Operator's Manual page 8

GENERAL OPERATION: Cont.
Once a process is selected, push the PROG key or the START/STOP key to confirm the Process Parameter Screen.
PROCESS PARAMETER SCREEN
This screen shows the name of the process selected, the number of lamps used and its cycle time (excluding the 3 minutes of
cooling time).
To return to the Process Menu press the ESC key or wait 15 seconds. The screen will return automatically to the main menu. A
timer is displayed at the bottom of the screen indicating how much time is left to start the process.
To run this process the START/STOP key must be pushed again.
Once started, the running process screen is shown.
PROCESS RUNNING SCREEN
The process will run for the length of the processing time displayed. The unit will pause at end of process to check table
rotation; a long beep indicates the start of the cooling phase. Remove the work and allow unit to cool.
CAUTION: Models may still be hot - Use caution when removing materials from chamber.
!
8