Poly Savi 7210 Office Manual

Poly Savi 7210 Office Manual

For desk phone
Hide thumbs Also See for Savi 7210 Office:

Advertisement

PLANTRONICS + POLYCOM.
NOW TOGETHER AS
Savi 7210/7220 Office
for desk phone

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Savi 7210 Office and is the answer not in the manual?

Questions and answers

Summary of Contents for Poly Savi 7210 Office

  • Page 1 PLANTRONICS + POLYCOM. NOW TOGETHER AS Savi 7210/7220 Office for desk phone...
  • Page 2: Table Of Contents

    Contents Overview Headset overview Base overview Accessories Hook up system Desk phone setup details Subscribe headset to base Automatic secure subscription Manual over-the-air subscription Ending subscription Fit and charge Wear on the right or left Charge your headset System basics Power on your headset Adjust volume Make, answer, end calls...
  • Page 3: Overview

    Overview Headset overview Subscribe Mute/unmute Power Subscribe Volume up Volume down Call NOTE **Functionality varies by application. May not function with web-based apps.
  • Page 4: Base Overview

    Base overview 4 5 6 Desk phone LED Telephone interface cable jack Subscribe LED Auto answer Charging LED Subscription button Wideband/narrowband audio switch Desk phone listening volume Power jack Desk phone speaking volume Handset lifter jack Desk phone configuration switch...
  • Page 5: Accessories

    Accessories Electronic hookswitch cable (EHS cable) Electronically and automatically answers/ends a desk phone call. Enables remote call control with your headset. HL10 lifter Automatically lifts handset and returns it to the cradle. Enables remote call control with your headset.
  • Page 6: Hook Up System

    Hook up system Using the diagram, connect your headset system. HEADSET PORT Desk phone Subscribe Battery status Wideband/ status narrowband Subscribe Auto-answer status NO HEADSET PORT Desk phone setup details Choose a desk phone setup A, B, C or D and connect cables.
  • Page 7 • Connect one end of the telephone interface cable to the back of the base • Disconnect the handset coil cord from the base of the desk phone and re-connect it to the telephone interface cable junction box • Finally connect the remaining end of the telephone interface cable into the open handset port on the desk phone •...
  • Page 8 • Adjust the configuration switch on the bottom of the base to default A, which works for most phones. Use configuration for Cisco phones.
  • Page 9: Subscribe Headset To Base

    Subscribe headset to base The headset and base that came in the box are subscribed (connected) to each other. However, if you wish to use a new headset or need to restore subscription to your current headset, the units can be subscribed to each other by the following two methods. Automatic secure With your system idle, docking a headset will automatically subscribe it to the base, making it the primary headset.
  • Page 10: Fit And Charge

    Fit and charge Wear on the right or left To position the microphone on the right or left side, rotate the microphone boom up and over. Gently bend the boom so it is approximately 2 finger widths from the corner of your mouth. Charge your headset Place the headset in the charge cradle.
  • Page 11: System Basics

    System basics Power on your headset To turn on the headset, slide the Power button. Adjust volume • Headset volume Fine-tune your headset volume by adjusting the volume controls. • Desk phone volume When you are on a desk phone call and your voice is too quiet/loud, adjust the microphone volume on the bottom of the base.
  • Page 12: Troubleshooting

    Troubleshooting Headset I can’t hear a dial tone in the • Make sure your headset is charged. headset. • Make sure your headset is subscribed to base. See Subscribe headset to base. • Adjust the configuration switch (A--F) on the bottom of the base until a dial tone is heard.
  • Page 13: Desk Phone

    People I talk to can hear a buzz in • Move the base further away from your phone. See Position Your the background. Base. • If the base power supply is plugged into a power strip, plug it into the wall directly. Desk phone The handset lifter is installed but •...
  • Page 14: Support

    Santa Cruz, CA 95060 2132 LR Hoofddorp United States Netherlands © 2019 Plantronics, Inc. All rights reserved. Poly, the propeller design, and the Poly logo are trademarks of Plantronics, Inc. All other trademarks are the property of their respective owners. 215231-06 11.19...

This manual is also suitable for:

Savi 7220 office

Table of Contents