DISPLAY MESSAGES - PROBLEMS _ CAUSES _ REMEDIES
24
The machine can guide the user for a correct use through its multi-function indicator.
Machine ready to dispense espresso coffee
and hot water.
Machine in warming phase for dispensing
espresso coffee and/or hot water.
Machine in Stand-by mode.
The machine goes into Stand-by mode after
60 minutes of inactivity. If the user moves the
capsule compartment opening lever, or pres-
ses the steam button, the machine will not be
in Stand-by anymore.
Machine ready to dispense steam.
Machine in warming phase for dispensing
steam.
spense hot water.
Boiler temperature too high; load the circuit.
Dispense hot water until the light becomes
green.
PROBLEMS
CAUSES
The machine does not turn
The machine is not
on.
connected to the power
supply.
The coffee is not hot
The cups are cold.
enough.
No hot water or steam is
The tube nozzle is clog-
dispensed.
ged.
The machine takes a long
Excessive scale has built
time to warm up.
up.
The capsule container can-
Capsule erroneously po-
not close.
sitioned.
REMEDIES
Check the plug and the
connection
Warm up the cups.
Clean the nozzle opening with
a needle.
closed and the machine
must be off.
Descale the machine.
Check the capsule position.
Replace it, if necessary.