Advertisement
Available languages
Available languages
The use of the mounting profile (item no. 4050006x, 4050002x) is permitted only in combi-
nation with the technical vaseline (item no. 63500020)!
When using the bracket set it is recommended to install a bracket approx. every 25 cm to
ensure a secure holding of the AQUALUC C:URVE WIDE.
The AQUALUC C:URVE WIDE must not be installed above any joints that may expand and con-
tract due to the ambient conditions. In particular, the thermal expansion of materials must
be taken into account.
When using mounting profiles, it is therefore recommended to proceed according to the follo-
wing rule: AQUALUC length in cm < mounting profile length in one piece. Failure to do so will
inevitably result in the LED strip being compressed or stretched and the warranty will expire.
If you use adhesive tape, please ensure that the surface to be taped is dry, even, and clean
(no fat, oil, silicone and dust particles). To achieve best adhesion, the surface of the AQUALUC
C:URVE WIDE should also be clean (if necessary clean the surface of the LED light line with
a soft, slightly damp cloth. To remove more severe stains use a standard cleansing material
without abrasive elements).
Fix the tape on the bottom side of the AQUALUC C:URVE WIDE or on the mounting surface
and press the LED light line firmly. The contact pressure should not exceed 10-15 N/cm
,
2
otherwise the LEDs or the electronic parts of the AQUALUC C:URVE WIDE could be damaged.
If you select the construction adhesive then it is important to ensure an even and slight wave
form distribution. The amount of adhesive used should be relative to the size of the required
adhesive surface.
ILLUSTRATION 1:
PLEASE NOTE BEFORE INSTALLATION
The product should always be installed by two people in order to avoid a sagging of the
LED light line.
Advertisement
