Advertisement
Available languages
Available languages
6. INSTALLATION AND COMMISSIONING
6.1 ASSEMBLY AND PROCESSING INSTRUCTIONS
Separate the mains voltage and power supply voltage of the power supply unit before ins-
tallation and connection!
The electrical connection may only be conducted by a trained electrician who has knowledge
of the applicable regulations!
Switch off the automated circuit breakers and unscrew the fuse. Also switch off the ground fault
circuit interrupter so that the mains supply line is separated from the mains voltage. Secure
the ground fault circuit interrupter so that it can't inadvertently be switched on - either with a
lock or with a warning sign.
Subsequently ensure that there is no voltage in the line with an appropriate voltage tester (e.g.
digital multi-meter).
A correctly dimensioned power supply unit and controller (extended functions) are required
for the operation of the LED light line.
For this see: Recommended controllers for the operation of the LED light line
• The processing temperature range of the AQUALUC C:URVE WIDE is between 15 °C and
35°C. Temperatures below this can negatively influence the flexibility of the light line and
can result in damage. If the AQUALUC C:URVE WIDE was previously exposed to lower or
higher temperatures, then it must be slowly brought into the processing temperature range.
• Please note that the AQUALUC C:URVE WIDE can marginally expand or contract with
changes in temperature at the installation location. This is not a defect in the product but a
normal physical process. Specifically, this means that there is a linear thermal expansion of
approx. 1 mm per meter and 15 °C change in temperature. This extra expansion gap should
always be taken into consideration prior to installation.
• To avoid damaging the AQUALUC C:URVE WIDE , especially during unrolling or mounting, it is
important that two people install the product. This is especially valid for a length of one me-
ter (1 m) or more. Care should be taken that the product does not sag otherwise irrevocable
damage can occur (see illustration 1). Furthermore, the encapsulation of the product may
not be damaged otherwise a sufficient protection of the LED light line cannot be ensured.
It is important to never exceed the minimum bending radius!
• The minimum bending radius of the AQUALUC C:URVE WIDE is 15 cm. The minimum ben-
ding radius may not be exceeded and the light line may not be bent, otherwise the AQUALUC
C:URVE WIDE could be damaged (see illustration 2).
• The product is suitable for installation on the floor, wall or ceiling - indoors and outdoors.
Make sure that the product is mounted on a clean, flat and stable surface.
The product has been tested for a maximum of 5 days in continuous underwater use. For
longer periods of underwater use we recommend our AQUALUC S:OLID underwater light line.
For further information please visit
Depending on the substrate and intended use, installation can be carried out using the
retaining profile (item no. 4010014x), the sets (item no. 4050001x or 4050002x), the heat-re-
sistant double-sided adhesive tape (item no. 30033009) or construction adhesive (item no.
63500030).
www.barthelme.de
Advertisement
