Sunrise Medical Switch-It CTRL+5 Owner's Manual page 7

INSTALLATION
Install the CTRL+5 in a location that is easy for the intended user to
access.
Only authorized Sunrise Medical dealer should install this product.
INDICATORS
The behavior of the indicators is dependent on the seating module in the
system.
1. With an Intelligent Seating Module (ISM) the indicators, Figure 6,will all
be green or yellow.
• Yellow indicates a drive inhibit is active and green indicates there is
no drive inhibit.
• All white indicators meant the module has not authenticated with the
powerchair.
2. With a Complex Seating Module (CxSM) the indicators, Figure 6, are
linked to the button below them.
• When a button is assigned to any other option but seating, the light
will be solid white.
• When a button is assigned to a seating Memory axis, and that axis is
running, the light will be blinking green.
• When a button is assigned to a seating Memory axis and a drive
inhibit occurs the LED will change to the drive inhibit color once the
axis is stopped.
• When a button is assigned to a seating Memory axis other than a
Memory axis the drive inhibit color change will happen when the
inhibit happens.
• The LED color will be Red for a lockout drive inhibit.
• When a button is assigned to any seating axis and no actuator
channel within that axis has called for a drive inhibit the LED color will
be Green.
PROGRAMMING ASSIGNABLE BUTTONS
1. Changing the assignable buttons of the Ctrl+5 should only be done
by an authorized Sunrise Medical dealer.
2. Connect powerchair to PC Programmer using a Programming
Dongle.
3. Read Chair into the programmer by clicking on the blue down arrow
in the toolbar, shown at right.
4. Open the Switch-It folder and the module you wish to change.
Figure 7 shows Button 1 of module 1 is assigned to Speed Up and
Speed Down.
5. To change this double click on the current assignment. In this case
you would double click on the "Speed Up" text. This brings up the
window as shown in Figure 8.
6. Now select the function you need that button to do by clicking the
checkbox, then click OK.
7. Continue this process until all buttons have the desired function
8. Now click the upload button, shown at right.
9. Now power cycle the chair. Your new assignments are now updated.
247780 Switch-It CTRL+5 with Assignable Buttons Rev.A
Indicator Window
Fig. 6
Fig. 7
Fig. 8
7