RFT Mother Transmitter Manual page 3

How do I replace damaged transmitter clamps?
1. Open the clamps all the way and gently remove.
2. Insert the first clamp by inserting the right oval-shaped pin into the hole on
the right side of the transmitter.
3. Next, line the left oval-shaped pin up with the hole on the left side of the
transmitter.
4. Gently snap the pin into the hole.
5. Close the clamp.
6. Repeat the previous steps for the second clamp.
NOTE: The transmitters may
be wiped, sprayed or rinsed
with water or the approved
cleaners during cleaning, but
must not be soaked. Soaking
transmitters may result in
equipment and/or system
failure.
www.rft.com/Resources/Manuals & Specs/Transmitters/Transmitter Approved Cleaning Solutions
3125 North 126 th Street, Brookfield, WI 53005
Technical Support: 800.669.9946, option 5 (tech@rft.com)
©2019 RF Technologies, Inc. All specifications subject to change without notice.
0510-1020 Rev P 01-20
How do I clean the transmitter?
1. Remove the banding material from the transmitter and dispose of it.
2. Disinfect the transmitter with an approved cleaner (*use of non-
approved cleaners can cause permanent damage to the transmitter
and piercing contacts and will void any and all warranties).
3. Allow the cleaner to remain on the transmitter for the amount of time
specified by the manufacturer. When using surface disinfectants and
decontaminant cleaners, always follow the manufacturer's
instructions.
4. Wipe the transmitter with a clean cloth or towel, and then allow the
transmitter to air-dry. The transmitter can also be rinsed with water, if
required to in the manufacturer's instructions.
5. Inspect the piercing contacts on the transmitter. The contacts must be
gold in color and not bent or out of alignment. If the piercing contacts
are NOT gold in color or are bent out of alignment, discard the
transmitter.
6. Close the clamps on the transmitter
7. Place the clean transmitter in a storage container for future use.
* For an up-to-date list of approved cleaning solutions, visit:
Customer Care: 800.669.9946, option 2 (customercare@rft.com)