Kenwood KMM-BT506DAB Instruction Manual page 40

Installation/Connection
4 Rub the film antenna gently onto the windscreen in the
direction of the arrow shown to allow it to stick firmly.
5 Remove the separator (tag 2) of film antenna (F)
vertically.
Separator (tag 2)
(F)
36
ENGLISH
6 Set the position of the protrusion of the amplifier unit
(G) with the K mark on the film antenna (F) and paste.
Do not touch the lead terminal or the pasting surface
(adhesive side) of the amplifier unit (G).
• When installing the antenna on the right side
Earth sheet
Lead terminal of the
film antenna (F)
Lead contact of the amplifier unit
(metal part)
• When installing the antenna on the left side
Earth sheet
(G)
7 Remove the film covering the earth sheet and paste the
earth sheet on the metal part of the vehicle.
Provide sufficient leeway for the earth sheet so that it does
not interfere with the interior parts (front pillar cover). Also
take care that the interior parts do not interfere with the
amplifier unit (G).
Set the position of
the protrusion with
K mark
Front pillar cover
8 Wire the antenna cables.
Use cable clamper (H) to secure the antenna to the pillar at
several positions.
9 Attach the front pillar cover back to its original position.
Be sure not to damage the earth sheet and amplifier unit (G)
when covering.
10 Connect the amplifier unit (G) to the DAB antenna jack
on the rear of the unit.
Note:
Make sure [DAB ANT POWER] is set to [ON] on the
(F)
[FUNCTION] menu in standby mode. (Page 6)
[ON] is selected initially.
Windscreen
Earth sheet
(G)