Table of Contents
Advertisement
Problem
The shaver is
not fully charged
after I charge it in
the SmartClean
system.
The nose trimmer
attachment pulls
at the hairs.
The nose trimmer
attachment does
not work.
Possible cause
You have not
placed the shaver
in the SmartClean
system properly, so
there is no electrical
connection
between the
SmartClean system
and the shaver.
You move the
appliance too fast.
The cutting
element of the
attachment is very
dirty, for instance
because some
nasal mucus has
dried inside the
cutting element.
Solution
Press down the top cap
('click') to ensure a proper
connection between the
shaver and the SmartClean
system.
Slowly move the
attachment around to
remove all unwanted hairs
in your nostrils.
Clean the cutting element
by rinsing it under the tap
with hot water. Switch on
the appliance and rinse the
cutting element once more
to remove any remaining
hairs
If rinsing the nose trimmer
under the tap does not
unblock the cutting
element, then immerse it in
a glass with warm water for
a few minutes. Then switch
on the appliance and rinse
it under the tap.
53
Advertisement
Table of Contents
