Frequently Asked Questions - Philips AVENT SCD609/00 User Manual

9 Frequently
asked questions
,I \RX GRQ W ÀQG WKH VROXWLRQ \RX QHHG LQ WKLV
section, you can get support at
www.philips.com/AVENT or contact the Philips
Consumer Care Center in your country.
Problems
My parent/baby unit will not
switch on.
My baby unit will not switch on.
I cannot establish a connection.
The parent unit beeps and the a
"NOT LINKED! CAMx OUT OF
5$1*( PHVVDJH LV ÁDVKLQJ RQ
I get interference. I can only hear
intermittently.
I cannot hear anything through
my parent unit.
My range is less than 150 metres/
490 feet.
20 EN
Possible causes
The unit is not connected to the
power supply.
The battery is empty.
The unit is not connected to a
power supply.
The units are out of range.
Parent and baby units are too far
apart.
The baby unit is switched off.
The units are out of range.
The parent unit picks up signals
from other appliances or baby
monitors.
The volume of parent unit is set
too low or it is on mute.
The units are out of range.
You have switched on the
automatic voice activation.
The voice activation sensitivity is
set too low.
Environmental obstructions may
be affecting your range.
Solutions
Connect the unit to a power
supply.
Replace the battery and make
sure that it is correctly inserted.
Connect the unit to a power
supply.
Move the units closer (see
"Operating range" )
Move the parent unit at least
1.5 metres/ 5 feet away from
the baby unit.
Switch on the baby unit.
Move the units closer.
Move the parent unit away
from other 2.4GHz wireless
appliances such as telephones.
Increase the volume of the
parent unit.
Move the units closer.
When it is activated, the video
is displayed on when the baby
unit picks up a sound. As long
as no sound is detected, the
video display is off to save
power.
Increase the voice activation
sensitivity.
Move the units closer.