Power Profile - Avocent Cyclades ACS 6000 Installation/Administration/User Manual

5. When the PAP authentication protocol is configured for the port, select the authentication type
from the PPP/PAP Authentication menu.
6. Click Save.
To configure callback users and phone numbers for ports with Dial-In Profile:
1. Select Appliance Settings - Ports - Dial-In Profile - Secure Dial-In - Callback Users. The
Callback Users screen appears.
2. Click Add.
3. Enter the name used to perform the callback in the Callback Users field.
4. Enter the phone number to call in the Callback Number field.
5. Click Save.
To configure PPP OTP users for ports with Dial-In Profile:
1. Select Appliance Settings - Ports - Dial-In Profile - Secure Dial-In - PPP OTP Users. The PPP
OTP Users screen appears.
2. Click Add.
3. Enter the username in the PPP OTP User field.
4. Enter the passphrase in the Passphrase and Confirm Passphrase fields.
5. Click Save.
NOTE: This PPP OPT user will establish PPP connection after being successfully authenticated.

Power Profile

An administrator can configure ports that are connected to PDUs and that are configured with the
Power Profile. The Power Profile node has the three sub-nodes:
• Login: If the login password is changed on a PDU of a certain type (Cyclades, SPC or
ServerTech), the administrator can optionally change the login password on this screen. This
password is used by the console server to communicate with the PDU. (Only one password is
supported for all PDUs of the same type.)
• Devices: Configure the PDU type, speed auto detection and the polling rate.
• Outlet Groups: Configure groups of outlets.
To configure a changed PDU password for ports with Power Profile:
1. Select Appliance Settings - Ports - Power Profile - Login. The Login Screen appears.
2. To change the password for an Avocent or Cyclades PDU, an Avocent SPC PDU or a
ServerTechnology PDU, enter the password in the appropriately labeled section.
3. Click Save.
Chapter 4: Using the Web Manager 37