Dirt Devil 360 REACH Manual page 17

Any other servicing should be done by an authorized service representative. if appliance is not
working as it should, has been dropped, damaged, left outdoors, or dropped into water, take it to a
service center prior to continuing use.
WARning
PROBLEM POSSIBLE CAUSE
Vacuum won't 1. power cord not firmly plugged
run
2. Blown fuse or tripped breaker.
3. No voltage in wall plug.
4. Thermal protector activated.
Dust escaping
1. Dirt cup full.
from vacuum
2. Dirt cup not installed correctly.
3. Rinsable and/ or Filter made
Smoky/burning 1. Belt broken or stretched.
smell detected
2. Brushroll is clogged.
Vacuum tools 1. Dirt cup full.
won't pick-up
2. One or both filters are clogged.
3. Stair + upholstery tool not
4. power carpet nozzle not
Poor suction 1. Dirt cup not seated completely.
2. One or both filters clogged.
To reduce the risk of personal injury - Unplug before cleaning or servicing.
into outlet.
with HEpA media not installed
completely.
spinning.
spinning.
POSSIBLE SOLUTION
1. plug unit in firmly.
2. Check fuse or breaker in home. Replace
fuse/reset breaker in home.
3. Check fuse or breaker in home. Replace
fuse/reset breaker in home.
4. Unplug and allow vacuum to cool for 30 min.
(This willl reset the thermal protector)
1. Empty dirt cup.
2. Review Dirt Cup removal & replacement.
3. Review Filter Removal and Cleaning.
1. Call our Dirt Devil authorized distributor.
2. Clear/remove debris from brushroll.
1. Empty dirt cup.
2. Remove both filters and clean.
3. Review tool section.
4. Review tool section.
1. Reinstall dirt cup make sure lid is closed
completely.
2. Remove both filters and clean.
17