Login To Device - Teltonika RUT240 User Manual

LED INDICATIONS
- Singal strength status LEDs turned on: the router is turning on.
- 2G, 3G and 4G LEDs constantly blinking every 1 sec.: no SIM or
bad PIN.
- Blinking from 2G LED to 4G LED every 1 sec.: SIM holder
not inserted.
- 2G/3G/4G LEDs blinking every 1 sec.: connected to 2G/3G/4G,
but no data session established.
- 2G/3G/4G LED turned on: connected to 2G/3G/4G with
data session.
- 2G/3G/4G LED blinking rapidly: connected to 2G/3G/4G with
data session and data is being transferred.
1. To enter the router's Web interface (WebUI), type
2. Use login information shown in image A when prompted for authentication.
3. After you log in, you will be prompted to change your password for security reasons. The new password must
contain at least 8 characters, including at least one uppercase letter, one lowercase letter, and one digit. This step is
mandatory, and you will not be able to interact with the router's WebUI before you change the password.
4. When you change the router's password, the
used to set up some of the router's main operating parameters.
5. Go to the Status > Network
the cellular performance try adjusting the antennas or changing the location of your device to achieve the best
signal conditions.
A.
http://192.168.1.1
Please enter username and password
Username
admin
Password
admin01
Login
ime mobile solutions GmbH • Borsigstraße 7-9 • D-93092 Barbing • +49 9401 9333-0 • info@ime.de • www.ime.de

LOGIN TO DEVICE

http://192.168.1.1
Configuration Wizard
page and pay attention to the
B.
Mobile Information
Mobile
Data connection state
IMEI
IMSI
Sim card state
Signal strength
SIGNAL STRENGTH LEDS
into the URL field of your Internet browser.
will start. The Configuration Wizard
Signal Strength indication (image B). To maximize
www.ime.de
is a tool
Connected
123456789012345
123456789012345
Ready
-79 dBm