Differential Pressure Sensor Service Buttons - OneVue A120 Installation Manual

Sense differential pressure sensor
Table of Contents

Advertisement

Segment
Description
CLOS
Door switch is in the Closed status.
Door Switch
Monitoring
enabled
No Signal
Indicates its last check-in to OneVue failed. This is commonly due a network connection issue.
• For wireless network use, a failed check-in may be due to the device is not within range of a wireless signal or the wireless
signal strength is not adequate for normal operation.
• For PoE or Ethernet use, a failed check-in may be due to a network connection cannot be established.
If the device is powered by AC or Power over Ethernet (PoE), the yellow LED indicator flashes during this state.
Signal Ok
Indicates its last check-in to OneVue was successful.
LOW -Battery Level
Device is in an Alarm state due to its estimated battery life is less than 25%.
From the start date of this state, its estimated battery life remaining is 30 days. This estimation is based on the use of lithium
1.5V batteries, 1 hour Logging Interval, 8 hour Check-In Interval, and adequate wireless signal.
If the device is powered by AC or Power over Ethernet (PoE), the yellow LED indicator flashes during this state.
Lbat
Device is an Alarm state due to its battery level is critically low.
Readings are not logged or transmitted your OneVue account during this state.
Up
A firmware update is being applied to the device.
Readings are not displayed, sampled, or logged during this mode.
Con
Device is in configuration mode. The config icon is also displayed.
Readings are not displayed, sampled, or logged during this mode.

Differential Pressure Sensor service buttons

A sensor has two service buttons located on the front of the device.
Button
Operation
The silence button clears the local reading alarm.
Silence
Button
During a reading Alarm state, pressing and immediately releasing the silence button
flashing, but does not acknowledge the alert in your OneVue account.
Audio alert resumes once the time period of the Resume Audio Alert setting has been reached. Audio alert settings are configured from
a sensor's gateway profile.
clears the audio alert and stops the red LED from
Page 7

Advertisement

Table of Contents
loading

Table of Contents