Fanimation EMBRACE FPS7955B Manual page 8

How to Hang and Wire Your Ceiling Fan (continued)
5. To set the code on receiver unit, slide dip switches
to the same positions as set on the remote. (Figure 4)
NOTE: Factory setting is all up. Do not use this position.
NOTE: The remote unit has 32 different code
combinations. To prevent possible interference from
or to other remote units, simply change the
combination code in the remote and receiver.
6. Connect wires using connectors as shown in
Figure 5.
7. After splicing and making the wire connections, the
wires should be spread apart and turned upward with
the grounded conductor (white), the equipment
-grounding conductor (green) and safety cable on one
side of the ceiling bracket and the ungrounded conductor
(black and blue) on the other side of the ceiling bracket.
(Figure 5)
ON DIP
1 2 3 4 5
Dip Switch
Black Wire
Blue Wire
from Receiver
from Receiver
White Wire
from Supply
Black Wire
from Supply
Black Wire
from Receiver
Blue Wire
from Motor
White wire
from Receiver
HARDWARE USED:
WIRE
CONNECTORS
8
Receiver Unit
Figure 4
Green Wire
White Wire
BLK_ANT
from Ceiling
from Receiver
Bracket
Green wire
from Motor
Black Wire
from Motor
White wire
from Motor
Figure 5
x 4
Green Wire
from Supply